Iduino 800x480 Touch Screen TFT LCD Display HDMI Module for Raspberry Pi 3 2 Model B and RPi 1 B+ A BB Black PC Various Systems SC7B
1.Please note Supported update Raspberry Pi 3 2 and RPi 1 Model B B+ BB BLACK supported
2.Power Supply is NOT included.for PI ,do not require power supply
3.There is a sticker on the LCD screen. Please peel off before use.
LCD Size : 7.0 inch (Diagonal)
Driver Element : A-Si TFT active matrix
Display mode : Normally White ,Transmissive
High Resolution: 1152,000 Dots (800 x 3(RGB) x 480)
SSD1963 touch panel controller
Dot pitch : 0.0642(W) X 0.1790(H)mm
Active Area : 154.08(w)X 85.92(H)
Module Size : 164.9(w)X100.0(H)x5.7(D)mm
Surface Treatment : Anti-glare
Color arrangement : RGB-Stripe
Blacklight : Highlighted LED lamp backlighting
TFT Power(pin Name: 3.3V): The power of the screen is 2.8-3.3V; not use 5V, all the Pin's voltage on the module
Can not be more than 3.3V.
Backlight power supply (pin Name: 5V): backlight power range is 4.5-7V.
Interface Type: 16 parallel
Operating Temperature : -20 ~ +70 degrees centigrade
Storage Temperature : -30 ~ +80 degrees centigrade
7inch HDMI LCD (B) x 1
HDMI cable x 1
USB type A plug to micro B plug cable x 1
RPi screws pack (4pcs) x 1
DVD × 1
SC7B 7 inch HDMI LCD(B) Using standard HID protocol, so that you can migrate its to your own systems
With the use of Pi Raspberry, support Raspbian?Ubuntu?Windows 10 IoT Single-Touch, Free drive.
When used as a computer monitor, support 10 / 8.1 / 8 / 7, Five point touch, Free drive
Support 864 x 480 x 24bit graphics content through SSD1963 controller .It also equips parallel MCU interfaces in different bus width to receive graphics data and command from MCU. Its display interface supports common RAM-less LCD driver of color depth up to 24 bit-perpixel. Warning: All data port voltage can not exceed 3.6V.
Capacitive touch control and has vertical and horizontal image flip function. Image 4:3 / 16:9 display format conversion.
Operating voltage: 12V 1A power supply current requirements within the above 2A, On board 400mA DC-DC Boost regulator to provide power supply to LCD backlight.
You can use multiple OSD operation commands or potentiometer to adjust the brightness and color.
Supports BB Black, comes with related images like:Angstrom. and also Supports Banana Pi/Banana Pro,comes with related images like:Lubuntu, Raspbian.We provided CD disk with related driver and souce code to you, If you are unsure about any of the technical issues.please contact us Freely.