This Lithium ion battery protection PCB protect single Lithium ion batteries with 8A continuous current. Lithium ion protection is necessary, as Lithium ion will explode when they are shorted circuit or overcharged, and damaged when they are over discharged.After Lithium ion is connected to the PCB, the board protect individual batteries from: 1. Over charging - Disconnect circuit when either battery is over 4.35V. 2. Over discharging - Disconnect circuit when either battery is lower than 2.7V. 3. Short curcuit protection - Disconnect when short circuit is detected. Connection: B+ - TO +ve of the 1st battery. B1 - TO -ve of the 1st battery and +ve of the 2nd battery. B2 - TO -ve of the 2nd battery and +ve of the 3rd battery. B3 - NO connection. B- - TO -ve of the 3rd battery. P+ - TO +ve of load/input. P- - TO -ve of load/input.
Supported Battery type? three cell 4.2V Lithium ion battery
Overcharged voltage protection?4.35V
Over-discharged voltage protection?2.7V
Maximum Continuous Current?8A
Maximum Peak Current ? 15A, <20ms