A simple 3 piece machined steel collet adapter for angle grinders providing flexibility of application and work area, ergonomics in operator comfort with two hand operation, safety in lower operating speed, reduced cost as an expensive electric or pneumatic die grinder, air compressor, hoses and filter regulator are not required. Simple machined design allows for rapid tool changes and small size (2.125" Long) allows for easy toolbox storage. The adapter allows the use of all 1/4 inch die grinder tooling on all angle grinders with 5/8-11 male threaded spindles. Including wire brushes, carbide burrs, cartridge sanding rolls, rasps, buffs, "Speed-Lok type discs of various diameters, aluminum oxide mounted points and "RotoZip" bits with a 1/8 inch adapter. Requires only a spanner wrench and one or two 3/4 inch open end wrenches for installation and tool changes. 4 1/2 inch angle grinders use approimately 7 amps. An air compressor typically uses 14-21 amps. This results in 1/3 to 1/2 the electrical use. A high quality die grinder is rated at only 1/2 horsepower. A small angle grinder is rated at 1 horsepower resulting in less stalling. The Angle Grinder Collet Adapter is not intended to replace die grinders, just allow the use of the tooling to craftsmen, contractors, and home owners who don't have access to an air compressor system. ALWAYS WEAR EYE PROTECTION AND PERSONAL PROTECTIVE EQUIPMENT WHEN USING. Proudly made entirely in the USA. US PATENT No. 7,717,771
No Air Compressor, No Die Grinder, No Problem! Use Die Grinder Tooling With Your Angle Grinder.
CNC Machined, Heat Treated, and Black Oxide Plated To Last A Lifetime. Made With Pride In The USA.
BEWARE OF CHEAP HEX DESIGNS THAT CAN DAMAGE SOFT WORK PIECES.
Plumbers & Electricians, Use A Cutoff Wheel And Cartridge Sanding Roll On Conduit & Tubing.
SHIPS USPS PRIORITY TWO DAY DELIVERY, US PATENT No. 7,717,771